Bematech SB9011D Manuel d'utilisateur Page 1

SB9011D All-in-one Touch POS Terminal USER MANUAL

9 Step 2: When installation starts, click [Next] to proceed to the next step. Step 3: Installation in progress

10 Step 4: Uncheck “Install PS/2 interface driver” and click [Next] to continue installation. Step 5: Uncheck “install RS232 interfa

11 Step 6: Select option “NONE”, click [Next] to continue installation. Step 7: When installing USB touch, please connect the USB controller and USB

12 Step 8: If there are additional touch monitors connected, please check “Support multi- monitor system”. Step 9: Select the destination locati

13 Step 10: Select the Program Folder to install the utility. The default is “eGalaxtouch”. Click [Next] to continue installation.

14 After install the driver successfully, identify the USB controller is installed as shown below. Touch function settings

15 Touch calibration Touch device line test

16 4 Troubleshooting 1) Terminal does not boot If the terminal cannot boot after repeated pressing of the power switch when connect to the power,

17 the hardware and reboot; (e) If the above steps do not resolve this problem, reinstall the operating system. 3) The touch screen does not respond

18 8) The cursor in the touch screen can only move in a small area or touch positions are inaccurate. (a) This situation usually occurs

1 Table of Contents 1 Overview ... 2 1.1 Safety Informatio

19 5 Specifications MODEL SB9011D 15” All-in-one Touch POS Terminal Main Board CPU Intel Atom Processor, D525 dual core 1.8GHz Chipset D525 + CH8

20 SB9011D All-in-one Touch POS terminal

2 1 Overview Thank you for purchasing the SB9011D all-in-one touch POS terminal, Bematech is committed to continuously improve product quality

3 monitor screen. Wipe it clean with a soft terry cloth applied with a mild solution  Do not share the same power outlet with high-power electrical

4 2 Installation Guide 2.1 Appearances

5 2.2 Rear panel I/O connectors At the rear panel of the SB9011D is a row of external I/O device connectors detailed as follows: POWER key: Turn po

6 3 Setup and Driver Installation 3.1 Motherboard BIOS settings The POS terminal has a BIOS (Basic Input Output System) chip on the mot

7 Main CMOS Setup Menu System Overview IP25X2 BIOS VER:1.00 AMIBIOS Version :08.00.15 2011-06-20 Item Help Built Date:06/20/11 ID:LIPVB8106 System

8 Exit Menu Exit options Item Help Save Change and Exit Discard Change and Exit Discard Change Load Optimal Default Exit system setup afte